Incra TS/LS Extruded Rail End Caps
Description
I have the TS/LS on my Sawstop table saw. When I get to close to it, I either snag my pants or scrape myself on the aluminum corners or edges. I designed the extrusion in SketchUp so I could make designs that would fit the fence. One of the items I designed and printed was an end cap to provide a softer ande to the extruded rails. I print these in sets of 4 so all ends get covered. It prints SNUG on my Bambu Labs X1C. This is intentional. I align it and give it a few LIGHT taps with a dead-blow hammer, and it seats great. It's still easy to remove by tapping the exposed ends of the pieces inserted in the holes with a dowel and a dead blow hammer. I take mine off every now and again when I need to make other adjustments or add jigs.
Statistics
Likes
0
Downloads
0