828 RC BOAT
Description
This remote-controlled boat is designed for family 3D printers. The printing process only requires printing in the correct orientation, eliminating the need for support structures, thus saving a significant amount of material.Additionally, the following accessories need to be purchased: 3× M3 65mm screws, 5× M3 60mm screws, 10× M3*20mm screws, a ChiHai RD370 motor, an MG90S servo,3mm*150mm complete boat shaft assembly (outer diameter of the bushing is 8mm, length is 100mm with 2mm Universal Joint )， a HOTRC CT6A remote controller, a HOTRC F08A receiver, and a QUIC RUN 1060 brushed electronic speed controller. You can purchase a suitable 12V lithium battery, and it is recommended to use a T-type connector (as long as it is consistent with the electronic speed controller).
Statistics
Likes
0
Downloads
0