Starboard steno keyboard case
Description
See my other submissions for the keycaps. This is a design for a case and spacer insert for the Starboard stenography keyboard. This print doesn't have the hole in the bottom of the case for a tripod mount, just extend the cylinder hole in the OpenScad file if you need it. I printed the insert in PLA, but the goal is to print it in a soft TPU to absorb some of the keypress noise. It's a tight fit and I had to file down one of the two top tabs that hold the board down. In hindsight, these tabs don't need to overhang by 2mm, 1.5 would be enough. To assemble : Align the insert with the underside of the PCB to ensure every bump fits in a spacing hole, then insert both of them into the case, lower-side first, then usb-c side last. Enjoy !
Statistics
Likes
0
Downloads
0