Sewing machine table
Description
This is a replacement organizer box for the Elna Supermatic. It counts two drawers, a case for the cams, a container for the burette, and storage for 18 spools. See the full contraption here! https://www.youtube.com/watch?v=m2xSFcBWdrs It may be compatible with other sewing machines but I highly recommand checking the dimensions before printing as it's a long print requiring quite a bit of filament (about 600-700g with 10% infill) *Measurements are as follow :* - *width of the part in the middle sliding under the machine's arm :* 70.2 mm - *thickness of this same part :* 15mm - *total length :* 146mm - *table height :* 70mm Print with supports everywhere *but block supports on a small part of the two slots on the top front of the gig* You'll have to pause the print *at layer 330* to insert two 4m nuts *on each slot* where you blocked the supports ! These will allow you to screw some tools and guides on the table I printed this 10% infill with gyroid infill and it's sturdy widely enough
Statistics
Likes
0
Downloads
0