Machinist tool box
Description
Toolbox I built to hold my minimal machinist tools. Has pocket on top for a Mitutoyo 6" caliper top drawer has pocket (divider) for an Altoids tin. Print two tops if you don't want the tin pocket I had to cut the main body into 3 parts to successfully print this (using bambu slicer w/joining holes/pegs) epoxied the printed parts together. I cut the box right below the drawer separator (so the two bottom parts were open), With full support in the drawer area the print kept lifting and warping. 3 pieces worked great, maybe your printer is better (I used a Bambu A1) and can do one piece. Latches are from Amazon. https://www.amazon.com/dp/B07VPD8X9S?ref=ppx_yo2ov_dt_b_fed_asin_title Also needed: 4x 1/4-20 x.75 shcs (handle mounts) 4x 1/4-20 nuts 9x m3x6 shcs (hinge stop, latch mounts) 9x m3 nut (hinge stop, latch mounts) 2x m3 x 18 (or 20) drawer latch 2x m3 nuts drawer latch 2x springs for latch (I used pen springs, cut to length) dia 5mm ish x 10-12ish I included m3 nut pockets in the base to mount feet but wound up gluing feet on. If you can find some small feet that can use a m3 screw use them, feet od 20mm max to bolt on
Statistics
Likes
0
Downloads
0