Parking Break for Flight Simulator
Description
A simple parking break mechanism for your homecockpit. The radial center design with the long holes will allow to mount the assembly in different positions. Besides the four parts to print you will need: - 1 rod of sufficient length, diameter 10mm - 1 to 3 headless screws, about M4/M5 (keeping the handle, the rod and spring in place) - Spring of sufficient length and strength, inner diameter peferably a bit larger than 10mm, suggested length 15 to 20cm) - Contact Sensor, suggested to mount with m3 screws at the small long holes - 6 screws M6x20, preferably with 12 washers
Statistics
Likes
0
Downloads
0