Meepo Voyager belt cover
Description
This cover is a press fit + Original screws from original pulley cover. When you clip and screw it, there aren't any vibrations. Expect some rubbing at the beggining, due to the small clearances and 3D printing tolerances, but don't worry, it won't harm anything and wil just sand and fit itself after some km. It's a so tight fit that may be a bit hard to find the way to put it the first times, buts it's perfectly doable, I attached a link to a video of myself disassembling and reassembling it (should have chosen a better angle, sorry). 32t and 36t version. Successfully tested 32t version, it's a bit recent, just done about 100km on the street. The main idea is to avoid breaking belts because of little stones when going offroad (always happens to me, because i'm always drifting and fooling whenever I gent into the dirt). Still haven't tried on dirt (I actually have my shoulder injuried and a fall would be a really bad thing), so feel free to try, comment and suggest! I think it would perfectly work on dirt too, bcs there's no clearance for any little stone to get in
Statistics
Likes
0
Downloads
0