Viking PE050171, 025084-000, PE050062, PD210002 Control Board
Description
This is the replacement for Viking vent hood. Model was designed to print without supports with 0.6mm hotend. To complete the project you need following parts: https://cdn.automationdirect.com/static/specs/cutsheet/HT8A_cutsheet.pdf x2 https://cdn.automationdirect.com/static/specs/cutsheet/HT8JDH3A_cutsheet.pdf x2 Instructions: 1. Assemble the panel. Latch spring insert in the side with the service hole (later you will be able to remove the panel with an awl tool). Normal latch to another side. Insert switches and install terminals into switches 2. Disconnect internal outlet on the right side 3. Redo the wiring of the hood. Neutral wire (white) connect with all other Neutral wires (all withes). Black Hot line wire split in 2 and connect to each switcher. The single wire from the fan (this the outlet on the left side), connect it to the output of switcher (any of them, but originally fan on right side). The paired red wire from the light connect to the output of the other switch (on left). 4. Connect internal right outlet on the right and check functions
Statistics
Likes
0
Downloads
1