Tilted Hamster Wheel (608 Bearing)
Description
This hamster wheel includes **4 printed parts** and a **608RS Ball bearing**, I got if from a fidget spinner, but every simmilar bearing should be fine. Make sure the OD is 22mm and the ID is 8mm, the fit on the base is tight, don't be afraid to push it in! - **Support**: is the main base, tilts the wheel base at 35° and includes a full plate to be buried under your pet chipboard - **Base**: the three shaft thing, used to house the 608 Ball bearing - **Pin**: used to connect the base, the bearing and the wheel - **Wheel**: well...you get it, the diameter is about 15cm Everything is designed to be printed without supports, just lay it flat on the table. I used adaptive layers on some parts to speedup the printing process (0.12 to 0.28mm) Happy printing:)
Statistics
Likes
0
Downloads
0