DJI O3 with BN-220 back mount and side guards
Description
# DJI O3 Air Unit with BN-220 GPS holder I used these designs as a base: - [DJI O3 GPRC Mark 4 Upgrade](https://www.printables.com/model/331900-dji-o3-gprc-mark-4-upgrade-with-antenna-gps-and-cr) - [Protection Mount by scratch83](https://www.thingiverse.com/thing:4782328) I have edited the holder from Tom to add support and combine it with scratch83's protection mount. Below are the changes I made: ## Modifications - **Antenna small holes removed**: Not needed for my design. - **Antenna fixer**: I designed an antenna fixer to hold the antenna tightly in place. It fits perfectly on my calibrated printer. - **Larger mount holes**: The holes where the mount attaches to the drone were enlarged to 6.5 mm. - **GPS mount tool hole**: Added a small hole under the GPS mount to use a tool for removing the GPS if it gets stuck. ## Final Specifications - **Total height**: 25 mm
Statistics
Likes
0
Downloads
0