Tyre Glue Down Clamp for 1/10th Offroad
Description
Heres a tyre glue down clamp I designed. I had seen other designs, which were very popular but just to download the designs were quite expensive imo, however for me the biggest design flaw was that you were screwing into bare plastic, this is fine if you are not going to be screwing and unscrewing constantly. I know quite a few that have bought that design and it didnt take long before they stripped. I designed this using the reference of my previous design but this is split into 3 parts, just needs 6x m3 nut (just a basic nut, not a nylon one) and 6x 16mm m3 bolt. You could get away with a little shorter bolt but actually a little longer maybe better as would mean you wouldnt need to unscrew totally to slide the tyre in however you will have the end of the bolt protruding when done up. It's easy to use, print 3, push the m3 nuts into the slots, slide around the tyre and tighten up bit by bit working your way around until its snug, then starting gluing around the rim. Make sure the glue is totally set before releasing the clamp.
Statistics
Likes
0
Downloads
0