Ukulele tuner - Model 3
Description
This is the third iteration of my ukulele tuners. This new version has a number of improvements. - Only two, #2 3/8 inch screws are needed per tuner, instead of 4 required for the model 2. - Reduced backlash - A new, easier to print, tuner knob (button) is included in addition to the older style. - Separate tuner knobs and worm gear files are included as well as a part with knob and worm gear together to print as a single part - A little bit smaller volume Like the Model 2, these are substantially stronger than my original version. On the downside, the previous Model 2 was designed to be compatible with commercial tuners, the Grover ukulele 9NB. The Model 3 tuners no longer have the same screw spacing as the Grovers to get them down from four to two screws. Check out my [Soprano Ukulele](https://www.thingiverse.com/thing:6534108), if you need a ukulele to go along with the tuners. It includes a new headstock designed to be compatible with the Model 3 tuners. For each tuner you will need - Base - Cover - Worm gear - Tuner knob - Gear - Two, #2 3/8 inch wood screws All parts were printed with 5 shells and 50% infill. I use a brim for the worm gear.
Statistics
Likes
0
Downloads
0