5KG Filament Spool Holder Stand
Description
Print 2 of these stands, and I used 2 5/16" 4-6" carriage bolts, 2 matching nuts and washers, and 2 skateboard wheel bearings heat pressed into a 1" PVC pipe. Essentially, you heat the end of the pvc pipe just enough to slightly soften, and then set the bearing on a flat surface, and push the pvc pipe over and onto the bearing then let it cool. Do the same for the opposite end of the pvc pipe. Then when both ends are done you put a washer then nut onto each bolt. Tighten the nut to allow about 2 inches from the head of the bolt and thread each bolt through the bearing into the PVC pipe ends. Then slide each of the carriage bolt head into the recess of the printed spool stands and loosely tighten the nut and washer down to ensure the bolt head stays put. Now you just need to pull one stand end out of the PVC pipe and you can load your filament spool on it! ENJOY!!
Statistics
Likes
0
Downloads
0