Simple Bracelet Gift Box
Description
I wanted to make a gift box for my bridesmaids for the bracelets I got them, since the boxes they came in were not to my liking. I had filament in my wedding colors, so I whipped this design up and they look great! There is just enough clearance for these to be a bit loose, but I did that because not all printers are the same. If it's too loose, I found that adding clear tape to the inside of the lid around the sides, where you can't really tell, works great! I printed this on regular PLA, but the test print was on HS PLA and turned out great too.
Statistics
Likes
0
Downloads
0