PLA Sony Xperia 5 iv case
Description
By having the phone case consist of two parts one being the sides and one being the back you can make the top and bottom layer count for the back zero and gave your infill pattern show up. You need to orient the parts correctly without changing their location to have a perfect match. If you use honeycomb infill twice by having two back pieces on top of each other you can change the infill "fill angle" and get some cool patterns. For the one in the image you need 90 degrees on one and 118 degrees on other honecomb pattern. Check the images for more info and use my prusaslicer profile if you want. You can also just not print the back piece and have a bumper case. I made the fit perfect for my printer, you may need to scale it slightly for yours to fit well. Holes on the case should be precise as well. I tried printing this with TPU but the results were not satisfactory even after multiple attempts. For some reason the sides don't fit well and start to seperate from the phone.
Statistics
Likes
0
Downloads
0