Mister PI Custom Case for Mister FPGA Project
Description
Custom Mister PI Case / Mister PI Gehäuse FPGA I didn´t like the design and the measurements of the original case from Taki Udon. So, I created my own case from scratch. This is my fully custom build case for Taki Udon´s Mister PI (Mister FPA clone). You don´t need any supports or rafts. I printed with a 0.4mm nozzle. The side with writings/logos/outsides should face to the printing plate. You can customize the look of the case with covers if you don´t need all the USB ports and also don´t like to see all these ports. I have included covers for the front (Ethernet side), the sides (SD card slot side and Snac Port Side), single USB port and single SD card/USB slot. Included in this package: - Top and bottom panel - Front, back and sidewall covers - Frontcoverplate (with and without USB port open) - Sidecoverplates for SD-Card and Snac Port side - Single USB cover - Single SD-Card/USB Cover Please Note: Depending of your Z-Leveling, the printer quality and the used filament you may or may not have to do some afterwork on the printed parts. The coverplates do snug fit into the USB ports. Installation: When you have successfully installed Taki Udon´s Mister PI Mega Pack then you have to remove the bottom spacers which connects the USB Hub with the FPGA Gaming Board. Remove the top screws from the A/V Board and install the spacers from the bottom on the top board. Now use 4pcs M3x12 threaded screws to connect the printed bottom panel to the USB Hub. Slide the Front-, Back- and Sidecover plates into the bottom panel. Set the three button extension knobs on the corresponding buttons of the A/V Board. Finally fit the top panel to the package with 4 pcs of M3x14 threaded screws. Optional: Mount the coverplates over the sidewalls.
Statistics
Likes
12
Downloads
60