Parkside PPWD 30 A1 Vaccum Eurobox Cyclone
Description
Clip in Eurobox Cyclone for Parkside PPWD 30 A1. Eurobox used: 1a-TopStore Design Eurobox 40x30x18 cm. Foam seal needs to be added to the lid. https://www.1a-topstore.eu/?a=5642&lang=eng Depending on the planned project, a higher box could be a better fit. The printed Euro_Box_Support parts are needed so that the vacuum will not deform the box and create a vacuum leak. Original hose connectors need to be disassembled to fit 3D printed adapters. Hose with an inner diameter of 38mm needed and a minimum length of 1.5m. This cyclone is a remix of: https://www.thingiverse.com/thing:5579910 For assembly, see original cyclone. All connectors are osVAC neo for a 38mm Hose. See https://www.thingiverse.com/thing:5253018 for more information. ---------------------------------------------------------------------------------------------------------------- Following parts need to be printed twice: Cyclone_Lid_Support_outerside.stl Cyclone_Lid_Support_innerside.stl Euro_Box_Support_1.stl Euro_Box_Support_2.stl Cyclone_Box_Connector.stl (for assembly, mark middel of box and aligning with small notch on part) ---------------------------------------------------------------------------------------------------------------- The following parts are optional only if you want to use OsVAC connector on the end of the vacume hose: Parkside_Hose_Connector_3.stl Parkside_Hose_Connector_OsVAC_to_Nozzle.stl
Statistics
Likes
27
Downloads
88