FLSUN SR build plate spacer
Description
This is a spacer for the FLSUN SR to make the textured glass tie-downs (comes stock with the printer) fit normally after adding the magnet for the PEI plate accessory. Also it looks cool! :D IMPORTANT: Make sure you adjust the Z0 height to a fair amount above the build plate (at least half an inch) before you add the spacers and switch to the textured glass. Then you can reset it after fastening on the plate. Otherwise, when you go to start a print, it will CRASH into the plate because the glass is a little bit thicker that the PEI.
Statistics
Likes
0
Downloads
2