Microphone Holder - Max 4
Description
This is a design for a microphone holder that is intended to hold 4 full size hand held mics upright. They can be printed without supports and the stalk can be printed multiple times and screwed together multiple times and still fit. Although I wouldn't recommend a 10 meter tall stalk since it will definitely topple over X) I recommend a high infill for the stalk and a thick skin so that it doesn't snap when you accidentally screw it tightly. Which also should be avoided. You might be able to tighten it real tight once or twice but after a while, standard PLA would wear down and the threaded insert would snap.
Statistics
Likes
0
Downloads
11