The Silent Night Customizable CPAP Silencer/Muffler for sleep apnea

Description

**NOTE:** This is compatible with standard rubber hose connectors (default 22mm, but it is customizable). If using the Resmed Airmini, or other travel CPAPs with non-standard hose connectors, an adapter will need to be used. # Introduction While using my travel CPAP (a Breas Z1 Auto) for treating my sleep apnea, the noise travelling up the hose have been bothering me. I have tested a couple of mufflers on the market, like the Breas Q-Tube and Breas Q-Lite, but have not been satisfied with the sound reduction, so I have been requiring ear-plugs. This design is fully customizable, but I have included 3 sizes which will be enough for most people, small (70mm long, small volume), medium (85mm, bigger volume) and large (100 mm, very big volume). I recommend the large variant for most people, but even the small design is quieter than the Breas Q-Tube/Q-Lite, so feel free to try them all out. Using these designs, I no longer have a need for ear plugs! I designed this sound absorption muffler/silencer to be easy to print and assemble, and use common materials. The muffler consists of 3 printed parts: An outer cylinder body, end cap, and inner mesh tube. There is also an optional gasket you can print in a flexible material like TPU, which can be used to improve the air-tight seal. You will also need to add a sound absorbtion material sheet, like a ventilation filter or cotton. # Assembly instructions: After printing, make sure to test that the muffler is completely air-tight before final assembly. Screw together body and end cap, cover one end and blow hard into the other, and ensure that no air escapes any gap. Submerge the muffler in water to figure out any holes/gaps. 1. Cut a sound absorption sheet (for instance ventilation filters bought in hardware stores) into a long strip, slightly less wide than the inner tube. 2. Roll up the sound absorption sheet around the inner tube, so it forms a thick padding around the tube. 3. Insert the tube and absorption material together into the cylinder body. If it is too large, cut and reduce the length of the sheet. 4. (Optionally) Insert the printed flexible gasket onto the end cap threading. 5. Screw in the end-cap into the cylinder. # Model parameters: ## Large (the default): Muffler_Length = 100; Chamber_Thickness = 15; End_Cap_Grip_Cutout_Diameter = 3; ## Medium: Muffler_Length = 85; Chamber_Thickness = 12; End_Cap_Grip_Cutout_Diameter = 2.5; ## Small: Muffler_Length = 70; Chamber_Thickness = 9; End_Cap_Grip_Cutout_Diameter = 2.5;

Statistics

Category

Tags