4" Leather Lap for Polishing Cabachons
Description
If you open the Fusion files, please be aware I'm a complete novice. I'm learning as I go. Needed a leather lap for final polish on cabachon's/stones. I printed it with the exception of the O-ring and TPU pad out of PLA. O-ring is flexible PLA and pad is TPU 95A. O-ring... This ring is to hold the leather onto the pad. It's tight so you'll need to stretch it a bit. Soaking the leather in hot water helps. Trim the excess after it's dried. Hardware: 4- 10-32x1 1/4 screws to attach to the motor 2- M4 screws to hold the strap on the motor 4-M3 screws to attach the shaft adapter to the plate 1- toggle switch (Lowes) 1- approx 8" square leather piece rough side out (suede from Hobby Lobby) 1- power cord (Lowes) 1-M4 insert and M4 set screw
Statistics
Likes
0
Downloads
0