Kobra 2 Neo PCB box for enclosure. STL updated, different than Pics!
Description
So I didn't reprint it to show the changes but mine is a rough draft where I drilled holes for the wires, printer connections and for wall mounting, the STL has mounting fillets with holes for wood screws, proper fan screw holes, and holes in the model for all the wiring. plus mine has the screen mounting block in the wrong spot. its corrected in the STL with a nice square hole for your screen cable, my screen is missing in my pics because I run klipper on my Neo. everything has been tested and lines up. just mount your PCB inside with some thick thread screws, the factory hardware works but its difficult to get the screws started. then screw it to the outside wall of your enclosure over a hole you drilled for the wires. Run your wires and fill/cover up the hole with something heat resistant. you're done! Printing instructions. PETG! no PLA! when I printed in PLA the screw standoffs snapped off where as PETG is much more robust. supports on, 4mm spacing with a 75% density on the support interface. print the lid at 100.5% because if you do straight 100% it'll be a really tight fit. might crack. I did 101% and it was too big and 100% was too tight. I kept 101% though, but 101% and 100% the screw holes still worked. I have a donation link in my profile as I'm refining and sharing all these in hopes of helping fund a prototyping project I'm working on but don't feel obligated to donate, I'd be happy just to see some makes! happy printing!
Statistics
Likes
1
Downloads
1