Citadel Painting Handle Extender
Description
Remix of SevenUnited's extender. Remix uses 4x M3x12 screws instead of M3x16. Came across some problems with it that I wanted to fix. 1. Extender wasn't useable for less than 50mm bases. Since the handle barely fits 40mm (and requires some "finangling" to do so), I wanted the extender to be able to fit 40mm. But the hex nut bar thing at the bottom prevents the extender from being set to a gap where 40mm would work. Fixed by incorporating the spot for the hex nut into the extender bar, rather than requiring a seperate hex nut bar thing. 2. When set to 50mm, cant remove the extender from the handle without unscrewing the adjustment bits. The hex nut bar thing again prevents the extender from being removed when set calibrated to a 50mm base. Also fixed by incorporating the spot for the hex nut into the extender bar. 3. Extender barely fits 60mm and requires "finangling". Easily fixed by just extending the "extender" bar out an extra half cm. 4. I didnt have M3 washers on hand, so added a chamfer to the screw hole base interface pieces instead. Also added lots of chamfers elsewhere to for the sake of chamfers are preferable to square corners.
Statistics
Likes
3
Downloads
6