AtomRC Dolphin - 19 motor mounts 19x19 16x16 - base plate, motor mounts, thrust angle wedges

AtomRC Dolphin - 19 motor mounts 19x19 16x16 - base plate, motor mounts, thrust angle wedges

Description

I have made 3 part types to easily mount and change motors on the AtomRC Dolphin. You will need to replace the plywood base plate with the 3d printed base plate. Then for every motor you wish to to mount, print a motor mount at the desired length to achieve CoG. You can easily change motors by screwing mounts on or off easily Part 1) Base plate Replaces the plywood mount glued to the airframe. Remove the plywood from the fuselage. Insert 4 M3 nuts in the 3d printed mount before glueing it to the fuselage. These nuts are needed to screw the 19x19 or 16x16 motor mounts with M3 bolts. Part 2) Motor mounts Different dimensions: - 19x19 and 16x16 mm crosses - align with the motor you wish to mount - length - 10mm to 40mm. It allows you to place the motor further away from the frame to help achieve CoG. 3) Wedges - 0,5 - 3,0mm If the thrust angle is off, then you can use these wedges to place between the base plate and motor mounts to achieve the appropriate thrust angle. Hardware needed: - 4x M3 nuts - 4x 10xM3 bolts

Statistics

Likes

0

Downloads

1

Category

R/C Vehicles