Fidget Springy Button - Quick and easy! Print in place with no supports!
Description
If you are familiar with the String Instrument Trainer, this is the same model reduced to a simple fidget toy! The squishy, springy action was so satisfying that I needed a more portable, streamlined version. Instructions are the same: I recommend you skip PLA and go with PETG at 20% infill. The spring lasts quite a while! Model is designed to be EASY print in place and supports are not necessary. After printing, press the button down until the button reaches the bottom of it's cavity to free everything up. It should spring back to around 80% original length. Allow to cool before doing this, as you can shorten the spring prematurely if done while hot. Can be tugged at gently to stretch out if the spring shortens over time. This is an original design free for anyone to use, although I am accepting tips! Messages are open to anyone needing to commission a print. Thanks for your support!
Statistics
Likes
1
Downloads
11