Vannystyle Pro DJI O4 Pro camera insert - Fixed angles
Description
Available in four fixed angles: 27°, 25°, 23° and 20°. * Full FOV in ultra wide (tested with my angle: 27°). * Just enough vertical space to mount an action cam and a bumper. * Lens is protected. Camera slides into the back of the part. * Print in TPU 100% infill with support. Slow speed for maximum precision. Face up. * Do not put a long screw in the pressnut below the camera, the original one is good. The camera is very close, that's why the part has some padding under. I created fixed-angle inserts because it was impossible to use at least one screw and get a decent angle and protection without modifications. 27° is the maximum I could get with space for action cam mount and bumper. Note: If you read this far! I haven't tested the FOV for 20°, 23° and 25°. However if you do and if you can see the frame (possibly in the bottom corners of the lowest angles), send me a screenshot and a photo showing the position of the camera in the quad. I might be able to estimate the offset and create a new model. Instagram: stormriderfpv
Statistics
Likes
3
Downloads
10