Filament holder for FlyingBear Ghost 5
Description
This is filament holder for flyingbear ghost 5. !!This holder can be installed only on the back of the printer!! If you want to use it on the left or right side, you should use another holder. For assembly are required countersunk head screw M3 8-10mm and M3 nut. Insert nut into slot on "tube holder", insert "tube holder" to sqare slot on base of "filament holder" and tighten the screw from reverse side of the base. After that insert ptfe tube into hole on "tube holder", put the "tube collet" on the ptfe tube and strongly push the collet into conical hole of holder. Pay attention to length of ptfe tube, it should be long enogh to let the printhead move freely without filament or tube crease. You are able to print only "filament holder" and use it without ptfe tube, but i don't recommend to do that. STEP with assembly is attached.
Statistics
Likes
1
Downloads
8