Raspberry Pi Camera Module 3 adjustable holder: 2 piece easy assembly, no extra parts.
Description
The version I remixed from was great, probably nobody is using it because the creator didn't post any photos. The slot makes it easy to slip the cable in and out so you can insert & remove the camera without unplugging. The slot for the camera was too narrow for me: it was 10mm wide vs the 10.8mm wide camera protrusion on my pi module 3 camera. I widened the slot to 11.2mm to suit. Print the base with no support I printed the holder with support only for the overhangs inside the camera holder part, the ball joint was fine with zero support (as per picture). The original creator said no support at all is required, I haven't tried that. Note that the photos are from the original design after I used a blowtorch to heat up a chisel & melt the slot wider, I have not actually built my design.
Statistics
Likes
0
Downloads
2