Modded top for Enclosure for 30x70mm perfboard
Description
A remix of **just the top section** of this [Enclosure for 3x7cm Perfboard](https://www.thingiverse.com/thing:3425753) created by [acbaruth](https://www.thingiverse.com/acbaruth) - **Note: you'll still need the [Base.stl](https://www.thingiverse.com/thing:3425753/files)** from his original to go with this remixed top! This version has **clearance underneath the standoffs/screw-holes**, so that there is room to fit a [D1 Mini (ESP8266)](https://www.amazon.co.uk/dp/B0754N794H) mounted on sockets, flush with the end of the 3x7cm perfboard. The D1 mini needs to be flush with the end, in order to allow the USB socket to be useable. The original top was unfortunately just a bit too tight to allow this kind of mount. **I advise using supports when printing**, because the standoffs are now technically 'floating'. I've not tested it without supports, so it's your call.
Statistics
Likes
0
Downloads
0