Flashforge Adventurer 5M - camera holder for OV3660 camera modules
Description
This is a mount that allows you to add a cheap camera module to your AD5M. Other than the holder, you will need: - an OV3660 camera module with a wide angle lens (should be ~5$ from Aliexpress) - a 5pins PH2.0mm female connector and wires (~1$) How to install: - Solder the wires to the module on the headers near the connector make sure you connect them correctly according to the pinout on the back of the screen (you need to solder only 4). - pass the wire through the hole in the frame behind the screen and attach to the white connector on it. Better turn off the printer before you do it. - position the module in the holder and use a self-tapping screw through the metal frame on the front-right. - Make sure to hold any slack of wire to avoid collisions with the head. - Rotate the lens for optimal focus. - If you use klipper-mode, make sure you change the resolution to 1920x1080 or 2048x1536, otherwise your view angle will be very narrow. Do it by editing /usr/libexec/camera-autostart.sh How to use under klipper-mod: - Either use the device page and add an IP camera or add a camera view on Mainsail/Fluidd - use http://<printer-IP>:8080/stream
Statistics
Likes
0
Downloads
0