Filament Guide for Reality Space Pi Drier
Description
I like to feed filament directly from my driers to the print head through a 2mm PTFE tube. The driver has an orifice to accept a tube but sometimes friction would pull it in a cause a jam or the filament would snag on the end of the tube. I made this little funnel that replaces the orifice. The top is an M8x1.25 thread with a snug fit for the tube. The bottom is a funnel to guide the filament. At the top of the cone is groove for a bun o ring. It requires no support. This is not long-term tested so feedback is welcome.
Statistics
Likes
0
Downloads
0