BioCo2 Dispenser
Description
BioCo2 dispenser calculated for ~180L fish tanks! I am using this design with the sugar/yeast method. Print with 100% infill to stop buoyancy. PLA will do. All you need to complete this item are: - A short piece of 4mm diameter pipe (about 4 to 5 cm) - Two 16mm suction cups There are different ways to mount the 4mm pipe to the dispenser. Whatever way you use, make sure the connection is gastight so the Co2 stays in the dispenser! I used a soldering iron to melt it in place. Then simply add the 2 suction cups to the post and stick them in your fish tank! Best place for this dispenser is right below your outflow. To make sure you do not poison your fishtank with an overdose of Co2 always use a dropchecker!
Statistics
Likes
0
Downloads
0