Hobby T-Pin Pusher
Description
An updated version of a no longer produced T-Pin Pusher. T-Pins are great for the traditional "build over plans" method of RC plane Construction. This simple tool saves wear and tear on your fingers, especially if harder grades of wood are used. A typical 3mmx 6mm rare earth magnet is embedded in a cutout that allows for pin holding while setting and pin capture while pulling. The fork on the tail end is used for removing pins from tight spots. The unique geometry allows for "flat printing" and the LH and RH configurations are only for a little more natural hold. Printed with PLA+ at normal settings with supports to help accuracy of the small cutouts - Flat "side" to plate.
Statistics
Likes
0
Downloads
0