Cleaningbrush Holder Neptune 4
Description
The solutions which glue the brush holder with double sided tape to the heated bed did not work when the printer bed heated up and then the brush came loose. This holder get screwed between the screw wheel and the bed support front left. The brush i used you can buy anywhere or at the big internet warehouse A....... I cut the brush from the grip and glued it with double sided tape on the holder. The macro I use on my two Neptune 4 is the following. I do not guarantee that it will work at your printer. Use it on your own risk. The macro heats up the nozzle. I use it before printing. So the nozzle do not get cool down in the macro. So it is your own duty to print afterwards or to cool down afterwards. But I added a second macro, one which do not heat the nozzle up and makes one cleaning move. First Macro with heating up the nozzle: [gcode_macro NOZZLE_CLEAN] gcode: G28 # Homing: G4 P1000 # wait 1000ms when the G1 X25 Y0 Z10 F1000 SET_HEATER_TEMPERATURE HEATER=extruder TARGET=240 #hochheizen TEMPERATURE_WAIT SENSOR=extruder MINIMUM=235 MAXIMUM=250 #warten G28 X0 Y0 G1 Y50 Z5 F1000 G1 X25 Y50 Z20 F1000 G1 X25 Y0 Z10 F1000 G28 X0 Y0 G1 Y50 Z5 F1000 G1 X25 Y50 Z20 F1000 Second macro without heating up the nozzle: [gcode_macro NOZZLE_CLEAN_COLD] gcode: G28 # Homing: G4 P1000 # wait 1000ms G1 X25 Y0 Z10 F1000 G28 X0 Y0 G1 Y50 Z5 F1000 G1 X25 Y50 Z20 F1000 G1 X25 Y0 Z10 F1000 G28 X0 Y0 G1 Y50 Z5 F1000 G1 X25 Y50 Z20 F1000
Statistics
Likes
0
Downloads
0