Toyota Rear Trunk Strut Bushing Replacement | 3rd Gen 4Runner
Description
These are just a simple design for spacers for your trunk struts to replace the worn out bushings. This is made specifically for a 3rd generation 4runner. Specifically, the Strong Arm 4286 struts, as long as the spacing is the same, these should work. I recommend using PETG just so it doesn't deform in hot environments. It printed in about 18minutes on a Bambu P1S and overall cost is about 15 cents in filament. For each side you'll need: 1x TopBushingInner 1x TopBushingOuter (the outer one is thicker and goes on the side facing into the trunk) Either 2x MainBTMBushings1-2Hole or 2x PrototypeBTMBushing7-16Hole. The main difference is that the prototype has tighter tolerances by 1/16inch however, I haven't been able to check if it would work. The main version is tested and work. In total you'll need For top sides of the struts: 2x TopBushingInner 2x TopBushingOuter For bottom side of the struts: 4x MainBTMBushings1-2Hole or 4x PrototypeBTMBushing7-16Hole
Statistics
Likes
0
Downloads
0