Car Jack Stand Ratchet Adapter
Description
This print is an adapter for a 21mm hex bolt (face to face) to a flat bar that is used for the ratchet I bought. The print has been created so that it can be adapted for a bolt that is up to 50mm face to face by changing it in the stl. I had printed it flat (the hexagon facing horizontally) in order to minimize the shearing across layer lines. This is the ratchet that I had bought: https://www.amazon.com/dp/B0B8HX8DDZ?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_2 PLEASE NOTE: This is a very tight press fit for the hexagon to fit over the bolt to minimize the chance of shearing/rounding of the plastic. The bar that the ratchet uses is 24.25mm x 45mm. I had lightly tapped it in with a hammer and there is a bolt hole to secure the bar if needed with a screw. The car jack is from a 2016 Nissan Maxima if that matters.
Statistics
Likes
0
Downloads
0