Guitar holder for classical guitars
Description
The template "BohrSchablone.stl" is not only for drilling holes, but also for adjusting the depth of the mounting screws, which need to be flat head screws. You can use the template to tighten the screws until it gets pressed against the wall, but you can still pull it out to the top. then you can position the holder and slide it down. In my case it fit like a glove and won't budge. The holder is a "wall only" part with built in supports, but if you choose very coarse resolution, the "fork" part might print poorly. Make sure you have good layer adhesion for obvious reasons. If you want to avoid scratches, there are the sleeves printable in TPU that fit over the fork prongs. You can also glue pieces of bycicle tube on there instead, if you have not TPU lying around. This was designed for wooden guitars, heavier models like an electric base guitar might work, but either way make sure your print is up to the task and won't come apart.
Statistics
Likes
0
Downloads
0