Skyrim Stalhrim Battleaxe - Resized and cut to print
Description
I increased the size by 500%, which is about half the size of the actual axe in game, then divided the axe into printable pieces. While I haven't run a test print yet, I believe it can be done without supports if you rotate the pieces to sit flat on the print bed. For the actual axe size, increase your print size to 200%, assuming your printer can handle that size. (I scaled it to fit my Anycubic Vyper, so I know it's possible at full scale.) I may go back at some point and put pegs into the pieces to make sure they line up correctly, but for now, you just have to be careful when gluing the pieces together to make sure they line up properly.
Statistics
Likes
0
Downloads
0