Top Shock End for MJX Hyper Go 1:16 16208 16209 162010
Description
I modified an existing design to fit for the MJX 1:16 Shocks. The manual says these 1:16 models 16208 16209 and 162010 all share the same shocks (spare part number 16500R 16510R). These shock ends might also fit to other models, could not test that. Circular base diameter: 11mm Total height: also 11mm I did two versions: - ShockEnd MJX 16208 3mmHoleScrewThrough: No need for a a Ball End, if you don't have any spare one or did not get it out of your broken shock without damage. The screw goes directly through the part to the shock tower. Without ball. For now, I ended up using this, as the movement on this small cars on the top end is minimal. - ShockEnd MJX 16208 6mmHole If you are lucky, you can press in your old Ball inside that 6mm hole. Good luck ..it's a tiny print. I printed it in PETG, roughness with PLA on this use case is unknown to me. I used like 10 layers of walls to get 100% infill to get it as solid as possible. Printed laying on it's side, you can try to move it up 15% or 30% the change the layer direction. It was an idea, but my first try was stable enough. Support: yes Brim: yes Infill: 100%
Statistics
Likes
0
Downloads
0