Bunnings Australia Tactix Case Ammunition Rack Insert
Description
I have created an insert for us Australian Shooters that fits inside one of those small sized Bunnings tactix cases. Link to the case is here: https://www.bunnings.com.au/tactix-tough-case-in-tan-small_p0331392?srsltid=AfmBOorPbR1X0DyFEN--lkDdCkix3RxVzL2I2BdPvpespQyZvBrSiEh2 This insert fits up to .308 in size. I designed it for my 6.5mm Creedmoor and my .308. Tube sizes are 14mm wide and 61mm high. There is a good 15mm of foam on top inside the lid, so any ammunition that is less than 14mm wide and y6mm long will fit. Print the model with the holes facing down on the build plate. This prevents the need for any supports. The print is 210mm by 141mm. It should fit on most printers. I used PLA+ but I honestly think you could use anything. - 50mm/second speed (The print des a lot of jumping between the cylinders, slow it down a tad so that it doesn't knock the print around. - 100% infill - No supports. - 210 C Hotend - 6 C Plate
Statistics
Likes
0
Downloads
0