Dragon Statue (32mm) and Dragon (32mm/54mm) (DND / TTRPG)
Description
This is a dragon statue - I had originally planned for outside of Argynvolsholt but I hadn't finished it in time (and came up with an alternate statue from an earlier broken resin print and a plinth in my decor collection). I think this statue makes a great little piece of decor for a haunted dragon castle, artwork in a draconid civilization or perhaps a point of worship for a cult of kobolds. I also adjusted the tail of the statue and then was able to crop it so that it could be standalone dragon figure on its hind legs. For sculpting I did the usual tracing and accentuating features from the AI output. I also added eyes and accentuated its sharp horns / wing spikes etc... Be care while removing supports on the 32mm model, especially on its horns as they can pop off. I printed this on its back at 0.05mm with a 0.2mm nozzle - I think scaling it up somewhat for 0.4 nozzles might be a good idea.
Statistics
Likes
0
Downloads
0