Dry Erase Lapboard Wall Holder
Description
These are designed to hold a 9" x 12" lapboard in portrait orientation. I print them in PLA. Use Command large picture hanging strips or equivalent to secure holders to wall. Note: I have had great success with the Command strips but bad experiences with standard adhesive-backed hook & loop tape that comes on a roll. Optional Installation Tool: If installing multiple sets of holders in portrait orientation, use the install tool and use a small level to ensure correct placement. 1. Apply Command strips to holders 2. Assemble holders onto installation tool (they should snap into place) 3. Place level on flat section of installation tool 4. Align assembly in desired location for lapboard and press against wall for a few seconds 5. Pull install tool away, leaving holders attached to wall
Statistics
Likes
0
Downloads
0