Geometric Heart wall art
Description
"Redefine Your Walls with Geometric Flair" Instruction: - It's basically 200 x 200 mm wall art that is dual color. You can use double-sided tape to mount it on the wall. For basic 3D print settings, here are some default guidelines that should work well for most prints, especially for beginners: Layer Height: Standard: 0.2 mm Fine Detail: 0.1 mm (slower print, finer detail) Print Speed: Standard: 50-60 mm/s Fine Detail: 20-30 mm/s (slower, higher quality) Infill Density: Standard: 20% (good for most prints) For strength: 50-60% Wall Thickness: Standard: 1.2-2 mm (3-4 wall lines) Temperature Settings: PLA: Hotend: 190-210°C Bed: 50-60°C ABS: Hotend: 230-250°C Bed: 90-110°C Retraction Settings: Retraction Distance: 4-6 mm (for Bowden extruders) Retraction Speed: 25-40 mm/s Support: Enable support: If overhangs or complex shapes Support Type: Grid or Tree Support (depends on your geometry) Cooling: PLA: Cooling fan at 100% ABS: Turn cooling fan off or set it at 30-50% Build Plate Adhesion: Raft or Brim: For models with small footprints or if warping occurs. Note: You need to change the filament after the base is completed. The choice of color for the heart print is up to you.
Statistics
Likes
0
Downloads
0