Coffeefilter Holder - Kaffeefilter Size 6
Description
I have no traditional coffee maker anymore, but a lot of filters, and I had to filter something. So quickly made a holder for the filters. I printed it in PLA as the liquid to filter is cold. But it should work fine for hot liquids if printed in ABS or Nylon etc ... It's got only one hole to filter slowly, and 3 additional 6mm holes where you can add some M6 screws as standoffs, or you just place it on a cup or something. I chose against adding some printed standoffs to the bottom as this would have involved a lot of support.
Statistics
Likes
0
Downloads
0