Apex 2" O4 lite and capacitor/antenna mounts
Description
I designed these parts to fit the Apex 2 frame (link to frame: https://www.amazon.com/gp/product/B0B7S6RKMC ) The o4 lite mounts are fixed angle. I uploaded files for 25* and 30*; the stl's are named accordingly. If you need a different angle please post a comment here, and I will generate an stl for it and upload it here. The rear capacitor and antenna mount are designed to fit a Panasonic FM 220uF 25V capacitor ( https://www.amazon.com/pcs-Panasonic-FM-Capacitors-220uf/dp/B073YQ4NR6 ), and any antenna that uses a ufl connector. The capacitor size is 8x12mm, and it is mounted vertically just in front of the rear posts. This fit the Betafpv 2-3s 20A aio I used, and should work fine for any aio that has the battery pad in the rear. I used the stock DJI stubby antenna on mine. I made the antenna tube extension and reinforcing flange to keep antennas with longer coax safe from the props. So if you use the stock antenna, you will have to trim the flange off, and trim the tube to about 6mm length. This is easy to do clean with just a few snips using flush cutters. I also used a bit of wire harness tape to secure the antenna to the cutoff tube. While I haven't had the quad more than a couple days before posting this, I've had the opportunity to rip at least 20 packs on my apex 2. The o4 video comes out nice and clean, and the parts have all held up will during hard crashes. Enjoy!
Statistics
Likes
0
Downloads
0