Bolt-on Lightweight Ducted fan-MakerGear M2 (& silent build recs)

Description

This Fan Shroud For Makergear M2 Allows For A Boost In Cooling At The Point Of Extrusion, Resulting In Higher Quality Prints And Steeper Overhangs Without Support. Alternatively, It Boosts A Quieter And Lower Output Fan'S Performance To Near-Or-Better Than The Stock Cooling Fan. Can Be Bolted On Stock Printer With A Few Fasteners (See Below). ~~**Edit 10-26-2015: Woops, This Might Only Work For People With 40X40X20Mm Extruder Fans. A Version For Stock 40X40X10Mm Extruder Fans Will Be Published Later**~~ **Edit 10-31-2015: Untested Mount And Shroud For 40X40X10 Extruder Fans Added. If You Do Test Before I Do, I Would Appreciate A Comment As To How It Worked Out.** Overhang Test Results: 45 Degrees -> 70 Degree (Stock Vs Low Speed Quiet Fan + Shroud) Features: - Boost Cooling Performance By Directing Air Where It Counts - Fan Output Is Centered, Not Offset. - 50Mm Fan Does Not Run Into Frame When Homing X Axis - Compatible With Aftermarket "Thicker" Extruder Fans, Such As The 40Mm X 20Mm. - Clears Stock Binder Clips - Lightweight Design What You See Here Is The 7Th Iteration Of The Design.

Statistics

Category

Tags