Fancypants Giants Causeway spool holder (20 mm ID)

Description

I Was Working On A Spool Holder Design That Holds A Spool At 45° So That It Can Be Printed As A Single Piece Without Support, And I Went A Little Wild. Hexagons Are Easy In Tinkercad, And This Arrangement Brings To Mind The Giants Causeway Rock Formation, Or A Pile Of Rubble On A Shoreline Being Licked By Surging Waves. This Holder Can Accept Spools With A Minimum Inner Diameter Of 20 Mm And A Maximum Outer Diameter Of 70 Mm. The Holder Should Work With Spools Of Any Height. The Bottom Of The Spool Is Evenly Supported By The Holder, And There'S An Eye To Pass The Spooled Material Through.

Statistics

Category

Tags