E3D Heater Block Micro Z-Probe
Description
I Designed This Bracket To Snap On To An E3D-V6 Heater Block And To Hold A Tiny Microswitch As A Z-Probe For Calibration. (Switch Source Http://Www.Goldmine-Elec-Products.Com/Prodinfo.Asp?Number=G16909 ) Wire Up A Disconnectable Harness, And Just Snap The Bracket On And Off When You Want To Run A Calibration Cycle. Note That The Stl File Has Printed Support Built Into The Model. The Stl File Contains 3 Separate Pieces. Don'T Use The Bracket While The Hot-End Is Hot.
Statistics
Likes
25
Downloads
0