Lulzbot TAZ 1 / 2 / 3 / 4 E3D v6 1.75mm Extruder / Hot-End Mount
Description
This Is An Extruder That Snugly Holds Your E3D V6 And Simultaneously Converts Your Taz To Use 1.75Mm Filament (Make Sure You Use The Ptfe Liner On Your E3D). It Drops Right Into The Standard Extruder Mount From Lulzbot, On Any Taz That Came With A Budaschnozzle (Before Hexagon Hot-End). If It Doesn'T Hold Your Hot-End Tight Enough, There Is A Bolt-Hole On The Front Of The Mount Where You Can Really Crunch It Down On The Hot-End. I'Ve Never Had To Do That, And I'Ve Been Using This Design For ~3 Months On My Taz 3'S Without Issue.
Statistics
Likes
14
Downloads
0