MKS / Makerbase 1.3" OLED case
Description
This Is A Case Designed For The Mks Oled Screen That You Might Find On Places Like Ebay, Aliexpress, Taobao Etc. Edit: This Was Made When Only A 1.3" Screen Was Available. Now 0.96" Screens Seem To Be More Common! Information: Http://Reprap.Org/Wiki/Mks_12864Oled Creators Not So Pretty Firmware Patch: Https://Github.Com/Makerbase-Mks/Mks-12864Oled I'Ve Made A Few Parameters So The Case Can Be Printed Shallow With Connectors Protruding Out The Back Or Deep With Connectors Completely Within The Case. There'S Also Some Supports Made Specifically For My Printer Setup Which Is A Tinyboy / Mini Fabrikator On 6Mm Tall Feet (Http://Www.Thingiverse.Com/Thing:981018). The Case Is Printed In Two Halves, There'S Some Lock Tabs That May Break Off For You Because They'Re On The Thin Side But They'Re Not Strictly Necessary As The Two Halves Friction-Fit Onto Each Other By Means Of The Four Square "Pillars" In The Corners Of The Back Side. These Also Serve The Purpose Of Supporting The Pcb From Behind So It Can'T Move When Buttons Are Pressed On It Etc. Edit: Posting A Link To This As It May Turn Out Extremely Useful To Somebody Wanting To Do What I Did, I.E. Get The Oled Supported On The Latest (At The Time Of Writing V1.1.0) Marlin Firmware. Here'S A Branch That Contains The Necessary Changes Provided You Use A Mks Base 1.1+ Mainboard (Fiddle With Pins For Any Other Board On Your Own): Https://Github.Com/X3Cutor/Marlin/Tree/Mks_Spi_Sh1106_Oled
Statistics
Likes
45
Downloads
0